DOCUMENT #2020

HOW TO SET UP THE INN-FORM PLUS FOR PMS-HB

(1)  You will not need an Ack or Nak so you may want to check
     Program #33 SMDR #34 and #35 and make sure they are both "0"
                                    
(2)  Use the "N" key to program the start and end of message
          Start of message 606 = LF = Linefeed
          End of message   607 = CR - LF - FF
          No Ack or Nak...   No Flow control.....
                                    
          Mgmt Access
          Start of message character
          Press "N" key
          Press "606" "ENTER"
          Press "Shift" then "6"
          Press "Shift" then "J"
          Press "ENTER"
                                    
          End of message character
          Press "N" key
          Press "607" "ENTER"
          Press "Shift" then "6"
          Press "Shift" then "M"
          Press "Shift" then "6"
          Press "Shift" then "J"
          Press "shift" then "6"
          Press "Shift" then "L"
          Press "ENTER"
                                 
(3)  Set SMDR Parameters Program #33
           #34 = 0  for no ACK
           #35 = 0  for no NAK

           #48 Controls the baud rate of the serial port.
           (221 = 300)     (204 = 600)     (255 = 1200)
           (17 = 2400)     ( 0 = 4800)     ( 34 = 9600)

           #50 Controls the protocol of the serial port.
           ( -1 =   8N1)     ( -2 =   7N1)     ( -9 = 8N2)
           (-10 =   7N2)     (-18 = 7Odd1)     (-22 = 7E1)
           (-25 = 8Odd2)     (-26 = 7Odd2)     (-29 = 8E1)
           (-30 =   7E2)
                                    
(4)  Press the Red Reset button on the back of the unit.
                                    
     REMEMBER TO SET PROGRAM #25 FOR YOUR HOSPITALITY MASK