DOCUMENT 2090

RE-INITIALIZATION PROCEDURE

Step #1   Go into management access and run PROGRAM #10, PROGRAM
          #20 and PROGRAM #32.  If you have programmed Automatic
          Multi Reports print out a Multi Report #7 for a copy of
          how they are set up.  These printouts clearly show any 
          on site programming that was done and can be referenced
          when re-programming the system.

Step #2   Run all reports that you need on the call         
          records stored in the memory of the unit. 
          *** THIS IS VERY IMPORTANT *** 
          because the call records will be erased after         
          the re-initialization.

Step #3   Go into management access, press PROGRAM #248 and ENTER. 
          You must press the red button on the back of the system
          to reset the INN-FORM/PLUS system.  Program #248 removes
          any glitches in memory and tells the unit to initialize
          and reset to factory defaults  The system will print out
          a program #10 and a re-initialization message.

Step #4   Re-program any on-site parameters (ie grace periods,
          surcharges, mark-ups, etc.).  The system is now ready to
          process call record information.